Cisco Catalyst WS-C3650-48TD-E is next generation of enterprise-level stackable access layer switch and integrates with 48 Gigabit Ethernet ports and?2 x 10G SFP+ & 2 x 1G SFP uplink ports in LAN base feature set.
Quick Specs
Table 1 shows the Quick Specs.
| Product Code | WS-C3650-48TD-E |
| Enclosure Type | Rack-mountable - 1U |
| Feature Set | IP Services |
| Uplink Interfaces | 2 x 10G SFP+ & 2 x 1G SFP |
| Ports | 48 x 10/100/1000 Ethernet ports |
| Maximum stacking number | 9 |
| Stack bandwidth | 160Gbps |
| Forwarding Performance | 104.16Mpps |
| Switching Capacity | 176Gbps |
| RAM | 4 GB |
| Flash Memory | 2 GB |
| Number of AP per switch/stack | 50 |
| Number of wireless clients per switch/stack | 1000 |
| Dimensions | 44.5 x 44.8 x 4.4 cm |
High-Performance IP Routing
The Cisco Express Forwarding hardware routing architecture delivers extremely high-performance IP routing in the Cisco Catalyst 3650 Series Switches:
● IP unicast routing protocols (static, Routing Information Protocol Version 1 [RIPv1], and RIPv2, RIPng, Enhanced Interior Gateway Routing Protocol [EIGRP] stub) are supported for small-network routing applications with the IP Base feature set. Limited static routing with the LAN Base feature set. Equal-cost routing facilitates Layer 3 load balancing and redundancy across the stack.
● Advanced IP unicast routing protocols (Open Shortest Path First [OSPF], EIGRP, Border Gateway Protocol Version 4 [BGPv4], and Intermediate System-to-Intermediate System Version 4 [IS-ISv4]) are supported for load balancing and constructing scalable LANs. IPv6 routing (OSPFv3, EIGRPv6) is supported in hardware for maximum performance. OSPF for routed access is included in the IP Base image. The IP Services feature set is required for full OSPF, EIGRP, BGPv4, and IS-ISv4.
● Policy-based routing (PBR) allows superior control by facilitating flow redirection regardless of the routing protocol configured. Virtual routing and forwarding (VRF)-Lite enables a service provider to support two or more VPNs, with overlapping IP addresses. The IP Base feature set is required.
● Protocol-independent multicast (PIM) for IP multicast routing is supported, including PIM sparse mode (PIM‑SM), PIM dense mode (PIM-DM), PIM sparse-dense mode, and source-specific multicast (SSM). The IP Services feature set is required.
● IPv6 addressing is supported on interfaces with appropriate show commands for monitoring and troubleshooting.
